Instructions for changing archwires
The InvisBrace archwire replacement workflow is presented step by step for clear, convenient chairside reference.
Note:
- Archwires 12, 14: go in 1 groove, can go in the upper or lower groove. In case the teeth are crooked a lot, go for the upper groove.
- Larger wire: 2 grooves; main groove (lower groove) for main wiring 16, 16×22, 17×25, 18×25; Auxiliary groove (upper groove) carries 16, 16×16, 18×18 auxiliary wires
- The secondary groove wire usually only goes through the 6 front teeth. In case you need to rotate the molars, route the auxiliary wire to tooth number 7, you need to break step 1 after tooth number 3 on the upper jaw.
Tools:
- Marker pen. Liquid composite. Optical lights.
- Wire press. Ligature Director and Twister
- Mathieu clamp with small head
- Ligature cutting pliers 40 degrees angle. Pin and Ligature Cutter Ever F.601 Angle 40
- Weingart Ortho Pliers Utility Ever Classic 422 Small Head Pliers
- 3-pronged quad helix pliers
- Ligature uses the thinnest type 0.008/0.009
Step 1: Weigh the main wire into the mouth and mark the length to bend the wire tail. If you replace (up) the archwires, you can compare them with the old ones to mark them.

Step 2: Bend the end of the wire with 3-prong pliers or small wire pliers to avoid poking the blade. Cut about 1 mm from the break.

Step 3: The liquid composite pump covers the end of the wire to avoid annoyingly poking the tongue.

Step 4: Measure the length of the extra wire by comparing it with the old wire or holding it in your mouth and marking.

Step 5: Bend the end of the auxiliary wire and cut it about 1 mm from the break so that the wire does not slide from one side to the other.

Step 6: Install both the main and secondary wires into the bracket and tie with ligature, using Mathieu clamps and wire presses.

Step 7: Cut off excess ligature with Ligature cutters at a 40 degree angle.

Step 8: Tuck the ligature end beneath the archwire using an archwire pusher.

Step 9: Apply a power chain for space closure after progressing to a sufficiently rigid archwire.

Completed

InvisBrace